Deployment Spots?

Xerkis · Post by **Xerkis** » Sat Aug 06, 2011 7:23 pm

I’m sure it is something simple – but I can’t figure out what I’m doing wrong with deployment of the units.

I have two scenarios that after the end of the first you obviously go to the second one. When I get to the second one I have plenty of core units to deploy – but none of my deploy spots are showing up.

I set a bunch of “Special Hex” deploy spots – regenerated the tiles – saved the file… but nothing.

Kerensky · Post by **Kerensky** » Sat Aug 06, 2011 9:11 pm

There are 4 kinds of deploy zones, you have to make sure you are using the correct one.

El_Condoro · Post by **El_Condoro** » Sat Aug 06, 2011 9:55 pm

When I'm testing a scenario I put one of each down and check which one works. Not ideal, but it has saved me a lot of time trying to figure it out!

Xerkis · Post by **Xerkis** » Sat Aug 06, 2011 11:35 pm

Shouldn't gray be the deployment for the Axis and green be the deployment of the Allied?

My scenarios and campaign are written from the Allied side. But gray deployment hexes work and green do not.
So what might I have wrong?

El_Condoro · Post by **El_Condoro** » Sun Aug 07, 2011 7:42 am

Yeah, I thought the same. My campaign has USSR as Axis and US (player) as Allies but the grey Axis deployment symbols work. I think it has to do with the order of Side 1 and 2 and perhaps the countries used but I have not made the time to test it fully. So, to date, it is still a mystery to me.