basing plastics.

ravenflight · Post by **ravenflight** » Fri May 27, 2011 9:14 pm

any advice on basing plastics?

They seem awfully light - is this a problem? should i use steel as bases to give extra weight?

Strategos69 · Post by **Strategos69** » Fri May 27, 2011 10:25 pm

Some people combine those bases with magnets to make transportation simpler. I guess the point with it is the thickness more than the material. I have FoW bases, which are thinner than my usual FoG bases and I have had no problems.

willb · Post by **willb** » Sat May 28, 2011 4:25 am

I have used artist mat board for my plastics. I had some on heavier bases and unfortunately the box they were in was knocked over. I had to spend some time gluing broken figures together that were damaged by the heavy bases. No such problem with the mat board.

ravenflight · Post by **ravenflight** » Sat May 28, 2011 5:05 am

willb wrote:I have used artist mat board for my plastics. I had some on heavier bases and unfortunately the box they were in was knocked over. I had to spend some time gluing broken figures together that were damaged by the heavy bases. No such problem with the mat board.

Thank's for the suggestion, but I'll either do it with steel and put flexible magnets on the base of the box, or do it with magnetized bases in the first place. Since using magnetized bases I don't think I'd ever use anything but something that can be magnetized.

philqw78 · Post by **philqw78** » Sat May 28, 2011 3:55 pm

I put plastics on pennies so I can pick them up easily when painting. I just leave the pennies on the bottom to add weight when I base.