Q: HP of units

[vexiliant]

aust.png (317.6 KiB) Viewed 1347 times

As far as I know, HP can only go up to 10, now how did they do it? Dev only?

(Picture taken from Australia scenario, Rising sun DLC)(I believe)

[terminator]

As far as I know, HP can only go up to 10, now how did they do it? Dev only?

(Picture taken from Australia scenario, Rising sun DLC)(I believe)

Difficulty settings (difficulty IV likely).

[vexiliant]

^ Confirmed (D. IV)

I = 6 HP
II = 8 HP
III = 10 HP
IV = 12 HP
V = 13 HP

[StuccoFresco]

Is it possible to edit those numbers to allow higher units' strenghts?

Like, if I wanted the max health to be 20, or 50, at every difficulty level.

[vexiliant]

Is it possible to edit those numbers to allow higher units' strenghts?

Like, if I wanted the max health to be 20, or 50, at every difficulty level.

I'm not too sure about that though, might have to do some digging.

[GabeKnight]

Is it possible to edit those numbers to allow higher units' strenghts?

Like, if I wanted the max health to be 20, or 50, at every difficulty level.

You can set unit HP individually with the #stimpack cheat, to a max. of 20.

[StuccoFresco]

Is it possible to edit those numbers to allow higher units' strenghts?

Like, if I wanted the max health to be 20, or 50, at every difficulty level.

You can set unit HP individually with the #stimpack cheat, to a max. of 20.

Too labor intensive, I'm afraid, and it can be done only in-game, not in the editor right?

Too bad.

[Erik2]

Many years ago I asked for a way to set max strength of a unit (also > 10).
I think this could be usable for the scenario designer.

[conboy]

Concur with Erik2!

conboy

[terminator]

The strength of the units varies according to the level of difficulty!