but I don't want to move that unit there

Celeborn · Post by **Celeborn** » Thu Jul 23, 2020 4:31 pm

I almost never plot movement of my units unless they have to travel a fairly long distance and I think the journey will be uneventful, yet since the May(?) update I am now frequently seeing units "ghost plotted" to move to locations I don't want them to move to. This has in some cases resulted in units moving when I didn't want them to--very frustrating. I have consequently been reduced to checking each non-moving units and if I find a plotted move I have to plot to move it to its current location to eliminate the "ghost plot" Has anyone else run into this or am I just going insane?

Erik2 · Post by **Erik2** » Thu Jul 23, 2020 7:50 pm

I've found that using the two-mouse button helps in avoiding wrong clicks.
You select the unit with the left button and select the location with the right button.
I have not seen this movement plot issue since pre 8.4.4.

Celeborn · Post by **Celeborn** » Thu Jul 23, 2020 8:40 pm

Will give that a try...thanks!

Erik2 wrote: ↑Thu Jul 23, 2020 7:50 pm I've found that using the two-mouse button helps in avoiding wrong clicks.
You select the unit with the left button and select the location with the right button.
I have not seen this movement plot issue since pre 8.4.4.

but I don't want to move that unit there

but I don't want to move that unit there

Re: but I don't want to move that unit there

Re: but I don't want to move that unit there