Bases removed after rout

philqw78 · Post by **philqw78** » Tue May 06, 2008 11:12 am

If a BG in corner to corner contact only pursues a routing enemy, along with the BG in, previously, front edge contact and all pursuers and routers move the same distance, the corner to corner group remains only in corner to corner contact. Does the routing BG loose a base for the enemy in only corner to corner contact with it as well as the BG that will be in full contact?

Heading up the page
^^^^^

Routers

In full contact

In corner contact

rich0101 · Post by **rich0101** » Tue May 06, 2008 11:24 am

If a BG is only in an overlap position that unit doesn't pursue. But if two or more BGs pursue and catch the broken BG then you lose one model for each BG that made contact after the rout.

philqw78 · Post by **philqw78** » Tue May 06, 2008 12:20 pm

According to a previous post it does pursue if only in overlap

see

viewtopic.php?t=6430

RBS reply

Also the question was does corner to corner count as contact to remove the base

WhiteKnight · Post by **WhiteKnight** » Tue May 06, 2008 12:38 pm

The overlapping BG counted as in contact for the melee that caused the rout/pursuit and had to pursue because it was in contact. So I would say that if it ended up in essentially the same position where it was able to cause hits in melee but now it is in contact with that BG as routers, it must cause an enemy router's base to be removed?

Martin

philqw78 · Post by **philqw78** » Tue May 06, 2008 12:48 pm

This is what I would assume

rbodleyscott · Post by **rbodleyscott** » Tue May 06, 2008 1:10 pm

philqw78 wrote:This is what I would assume

Good assumption.