Page 1 of 1

Custom Army Doesn't Work

Posted: Fri Mar 27, 2020 5:38 am
by SJS87
In the advanced options custom army doesn't work.

Re: Custom Army Doesn't Work

Posted: Fri Mar 27, 2020 5:39 am
by nexusno2000
SJS87 wrote: Fri Mar 27, 2020 5:38 am In the advanced options custom army doesn't work.
It works.

It gives you a deployment phase (turn 0) in the first scenario, where you can buy/disband/upgrade as you please.

Re: Custom Army Doesn't Work

Posted: Fri Mar 27, 2020 8:20 am
by Rood
Ah, I also thought it didn't work. Thx for the headsup!

Re: Custom Army Doesn't Work

Posted: Mon Mar 30, 2020 2:27 pm
by Magic1111
nexusno2000 wrote: Fri Mar 27, 2020 5:39 am It gives you a deployment phase (turn 0) in the first scenario, where you can buy/disband/upgrade as you please.
Perhaps that should have been better described, I would have expected an empty battlefield with full prestige points. Not that I have to manually dissolve the units, even if it only takes a few seconds.

Re: Custom Army Doesn't Work

Posted: Mon Mar 30, 2020 2:58 pm
by gunnergoz
Yeah, I too wondered why the battlefield was not empty, until I discovered that I could remove units and buy new ones. Not sure if this is part of the same selection, but I do like that I can place units in reserve in any minimalist form I want, preserving their experience while saving prestige and unit slots. For instance I can take an excess, experienced overstrength pioneer with a halftrack that I don't need in an operation, and demote him to bridge infantry with minimum troops, then place him in reserve, saving loads of prestige points and space slots in the process that I can apply, for instance to purchase a new unit needed for that operation.