[Editor-Request][Select Deployment/Exit zones][Why not?]
Posted: Tue Nov 15, 2022 12:39 pm
Another issue that could make an editor's life easier: selecting deployment hexes to edit them afterwards. Otherwise, you can't check for available turns afterwards.
Same for exit zones, but applies sadly even during playing: is this exit now for planes only or for land/naval & planes?
The animated arrow pointing out of a door frame is also misleading that it's rather a deployment point. Why not pointing inside the frame, like the known exit signs with a dude entering a door?
Not to mention the redeployment animation that looks like a V2 launch site. See below the picture for maybe easier to understand icon for redeployment.
Different little land/naval/air combination symbols inside deployment/exit zones could help, but obviously makes a lot of work again.
I know, suggestions for the void, but at least I can't blame myself for not pointing later.
Same for exit zones, but applies sadly even during playing: is this exit now for planes only or for land/naval & planes?
The animated arrow pointing out of a door frame is also misleading that it's rather a deployment point. Why not pointing inside the frame, like the known exit signs with a dude entering a door?
Not to mention the redeployment animation that looks like a V2 launch site. See below the picture for maybe easier to understand icon for redeployment.
- Exchange.jpg (1.97 KiB) Viewed 176 times
I know, suggestions for the void, but at least I can't blame myself for not pointing later.