Page 1 of 1

Replacement Source question

Posted: Mon Dec 23, 2019 8:00 pm
by conboy
Hidee-ho. Hope everyone is set for a fine holiday.

I am finally turning the corner on my campaign. The question is -- Is it possible to ensure that players can only draw replacements from dead units? I would like the composition of the units in play to basically remain the same throughout the campaign, except for some upgrades dictated/offered by the calendar. That would also avoid players from having to reassign original names. So if the 1/30th Infantry Battalion got wiped out, then the player could draw that unit from the dead pool (paying RPs to replace of course) but not any other type of unit.

thanks! Merry Christmas to you all, respecting your religious preferences. Time for peace and family for our great little community here.

conboy

Re: Replacement Source question

Posted: Mon Dec 23, 2019 9:49 pm
by GabeKnight
conboy wrote: Mon Dec 23, 2019 8:00 pm Is it possible to ensure that players can only draw replacements from dead units?
Sure, e.g. it's been done by Edward (in his case: by mistake, I think) here. Must be core units and new unit purchase not allowed in the editor.

Re: Replacement Source question

Posted: Tue Dec 24, 2019 4:45 am
by conboy
Thanks, Gabe!

conboy

Re: Replacement Source question

Posted: Tue Dec 24, 2019 12:30 pm
by Erik2
Try to uncheck the Purchase checkmark.
purchase.jpg
purchase.jpg (98.51 KiB) Viewed 706 times