Problems with Panzer Corps Gold
Posted: Sat Feb 25, 2017 3:44 pm
I have been playing Panzer Corps for a few months now with no real problems except that the Greece scenario always crashes. I recently purchased the Steam version of Panzer Corps Gold but I can't get any of the campaigns to run successfully. Panzer Corps itself still runs.
When I load the Polish campaign for instance, there are no opposing units, just Polish flag hexes where the units should be. I can just roll my units to them and capture them with no opposition. Afrika Corps sometimes loads, but crashes. Some of the other campaigns load the maps but there are no opponents or German units. So far none of the campaigns have loaded and run properly.
I'm running version 1.30 of Panzer Corps on a Dell Inspiron 3847 with 12 GB of RAM and the built in Intel graphics set. I'm on Windows 7 Professional Service Pack 1. I'm considering getting a separate graphics in the hopes that might solve my issues. I figure it's either that or the operating system but I hate Windows 10 and don't want to switch. Any ideas\help? I'd really love to play all these campaigns.
Also, is there a good unit editor out there for PC? I'd like to adjust the values of some of the units.
Thanks
Mike
When I load the Polish campaign for instance, there are no opposing units, just Polish flag hexes where the units should be. I can just roll my units to them and capture them with no opposition. Afrika Corps sometimes loads, but crashes. Some of the other campaigns load the maps but there are no opponents or German units. So far none of the campaigns have loaded and run properly.
I'm running version 1.30 of Panzer Corps on a Dell Inspiron 3847 with 12 GB of RAM and the built in Intel graphics set. I'm on Windows 7 Professional Service Pack 1. I'm considering getting a separate graphics in the hopes that might solve my issues. I figure it's either that or the operating system but I hate Windows 10 and don't want to switch. Any ideas\help? I'd really love to play all these campaigns.
Also, is there a good unit editor out there for PC? I'd like to adjust the values of some of the units.
Thanks
Mike