Slitherine

I created a new scenario to test and after playing it once, I want to make adjustments to it. But I can't find a way to 'load' it into the editor. It looks like my only option would be to recreate it from scratch and then make adjustments from there? Is that correct? What am I missing?

Thanks in advance

go back into the editor and just press the button to load the game you wish to edit on the left hand side of the screen, then you can re edit it, but remember to save it after your done, good luck which leads you to this screen and the ones you made

Ah OK, got it. Thanks! I was thrown off by the button being labelled as "Play" rather than 'Save/Load' or somesuch.

Works fine! Thanks again.

good luck and have fun commander, may the dice always roll in your favour

Thanks for the scenario editor. I would like play with commonwealth troop too. Is it possible to develop the game for it?
Best regards

Hopefully yes to Commonwealth but honestly I think the Amis/Germans need addition option first. Currently you can't really make a large battle because we just don't have the units for it. Even 400 point (which is within the recommended range for 2x2 map) uses up a good chunk of the forces and you practically have to buy both base companies every game.

There is a LOT of stuff for the board game that could be done (at least through the army boxes). Without it, the matchups in anything over a few hundred points is going to be similar time after time.

I edited my first scenario at 600 points with about ten orders per army.
We will try it but with an extra large map (5 tiles x 5), it's difficult to moove the screem in deployement phase bacause I split the area for it .
You can't roll back back zoom enough.
But I 'm very exited to play now.
Just one option will be interesting for scenario editor, give possibility to delay reinforcement with an arrival turn later in the scenario.