Page 1 of 1

"Stuck" AI

Posted: Sat Jun 22, 2013 3:29 pm
by Uhu
I'm creating a scenario where I encountered the following problems: I set goals, circumstances, etc. and a few units. The issue is that the units of the AI do not make anything: just staying on the starting point. There are VH-s so I don't understand what's happening. As I remember I encountered earlier a similar situation where the only "solution" was that I used an earlier version of that scn - where magically the AI become active. At this scn I cannot do the same and anyway I'm curious if anybody else encountered this problem?

Re: "Stuck" AI

Posted: Sat Jun 22, 2013 3:37 pm
by nikivdd
- Set AI as attacker (scenario parameters, sides tab)
- Set stance attacker per individual unit

Re: "Stuck" AI

Posted: Wed Jul 03, 2013 3:48 pm
by Uhu
It seems that the problem was that no Allied airfield was presented on the map therefore the Allied planes didn't do anything.