Slitherine

Just purchased the PC2, Axis 42 campaign. In the first scenario I can make my original deployments. However, in subsequent turns, even though i can purchase equipment there are no deployment hexes available for me to use and I cannot deploy units during the game even tough they are available to purchase. Again, this is after the initial deployment phase.

Am I missing something or is this a game flaw?

Thanks as always.

There is no Supply Hex in the first scenario but you can always deploy planes

Haze0008 wrote: ↑Sun Dec 26, 2021 1:47 pm Just purchased the PC2, Axis 42 campaign. In the first scenario I can make my original deployments. However, in subsequent turns, even though i can purchase equipment there are no deployment hexes available for me to use and I cannot deploy units during the game even tough they are available to purchase. Again, this is after the initial deployment phase.

Am I missing something or is this a game flaw?

Thanks as always.

"Haze0008"... you are not alone with this issue!... I have just had '2'- of the exact same experiences that you have just had. I hope this festering situation will be taken care of.

You have to deploy all the land units during the deployment phase, after it’s too late, it’s a choice of the scenario designer, it’s not a bug

I am not currently aware of situations where additional influxes of troops and equipment were not possible to be later added to the current or initial deployment of a task-force. Why-not... where it is not betraying a historical situation... to then allow for additional future deployments of Troops and Equipment?.

Not allowing deployment after the first turn is a special case situation, because the 1942 DLC starts with a very non-traditional scenario.

As the briefing goes over, you have to risk deploying to encircled positions, and then breaking those forces out of their encirclements, to bring your whole army to full deployment strength.