Slitherine

I think the patrol points were added in a list in the task settings earlier.
How else are you going to remove a single point...
In the screenshot I've added 3 points, but only the first one is displayed.
Also, whenever you add a new point, the map camera moves to the last one created which is annoying.
(this is the same way it works when adding objective map markers, just as annoying and inefficient).

Erik2 wrote: Tue Dec 01, 2020 3:05 pm I think the patrol points were added in a list in the task settings earlier.
How else are you going to remove a single point...
In the screenshot I've added 3 points, but only the first one is displayed.
Also, whenever you add a new point, the map camera moves to the last one created which is annoying.
(this is the same way it works when adding objective map markers, just as annoying and inefficient).

If you want to remove a Patrol Point, click on Remove and then select the Patrol Point on the map you want to remove

OK, but then you need to hunt around the map for that single point, always being sent to the first patrol point.
If there was previous/next buttons this would work better.

Does the Set Base function work ?

Looks like it, but I have not testet to see if the AI air units actually follow their orders.